no device detected using jtag

Using Zynq Programmable Logic and Xilinx tools to create custom board configurations

no device detected using jtag

Postby parallella-project » Thu May 31, 2018 11:32 am

I've create a new parallella project in Vivado by using this project:
https://github.com/parallella/parallell ... o/releases

one thing is that when I run the project the status changes to "route_design complete, Failed Timing!". I don't know if it's related to my problem.
the main problem here is that when I'm trying to "open hardware manager" and "open hardware target" and and "connect to local server" there is nothing in the hardware devices! (there is a "xilinx_tcf" in hardware targets)
So what should I do?
I'm using xilinx JTAG programmer and connected through the porcupine board.
parallella-project
 
Posts: 14
Joined: Sun Apr 30, 2017 5:06 pm

Re: no device detected using jtag

Postby olajep » Fri Jun 08, 2018 2:15 pm

Might be a permissions problem:
https://www.xilinx.com/support/answers/66440.html

// Ola
_start = 266470723;
olajep
 
Posts: 140
Joined: Mon Dec 17, 2012 3:24 am
Location: Sweden


Return to FPGA Design

Who is online

Users browsing this forum: No registered users and 12 guests

cron