Jumper J15 not powering the mounting hole
Posted: Mon Feb 09, 2015 7:25 pm
I'm trying to power a fan at this point, from the mounting holes. The soldering went well, and the first board works fine. I now have no power to the mounting hole on board #2. I tried switching the actual jumper connector and it seems to have no effect. Both boards work as expected when powered via the barrel connector.
So in effect, I soldered the connection advised for the power via the mounting holes on the two boards I bought. Now only one of them can be powered via the mounting holes. Wondering if anyone else has this problem? I'm afraid it may be a bad jumper or something. The solder is clean and no other parts are connected. Advice? (reprint from Technical Q&A now deleted)
So in effect, I soldered the connection advised for the power via the mounting holes on the two boards I bought. Now only one of them can be powered via the mounting holes. Wondering if anyone else has this problem? I'm afraid it may be a bad jumper or something. The solder is clean and no other parts are connected. Advice? (reprint from Technical Q&A now deleted)