[phpBB Debug] PHP Warning: in file [ROOT]/includes/bbcode.php on line 112: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead
[phpBB Debug] PHP Warning: in file [ROOT]/includes/bbcode.php on line 112: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4688: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3823)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4690: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3823)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4691: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3823)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4692: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3823)
Parallella Community • View topic - Mechanical exports error ?

Parallella Community

Supercomputing for Everyone
https://parallella.org/forums/

Mechanical exports error ?

https://parallella.org/forums/viewtopic.php?f=23&t=552

Page 1 of 1

Mechanical exports error ?

PostPosted: Wed Aug 14, 2013 12:45 am
by tnt

Re: Mechanical exports error ?

PostPosted: Wed Aug 14, 2013 7:57 am
by tnt

Re: Mechanical exports error ?

PostPosted: Sat Aug 17, 2013 4:01 pm
by aolofsson
Hi Sylvain,
Thanks for the feedback.

1.) We will check with the the board layout person to find out what happened with the export. (.emn)

2.) Based on Cadence allegro layout the 0,0 position is the center of the connector.

3.) I think the deviation on the two connectors is OK, but if someone feels differently please let me know? The PCB deviation spec is +/- 10mil.

Thanks,
Andreas