[phpBB Debug] PHP Warning: in file [ROOT]/includes/bbcode.php on line 112: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4688: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3823)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4690: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3823)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4691: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3823)
[phpBB Debug] PHP Warning: in file [ROOT]/includes/functions.php on line 4692: Cannot modify header information - headers already sent by (output started at [ROOT]/includes/functions.php:3823)
Parallella Community • View topic - GPIO and Porcupine

Parallella Community

Supercomputing for Everyone
https://parallella.org/forums/

GPIO and Porcupine

https://parallella.org/forums/viewtopic.php?f=13&t=3667

Page 1 of 1

GPIO and Porcupine

PostPosted: Mon May 02, 2016 4:32 pm
by Max Strange

Re: GPIO and Porcupine

PostPosted: Fri May 06, 2016 4:45 pm
by Max Strange
So I tried re-imaging my parallella with the old Ubuntu image (2015.1), and everything works fine. The GPIOs start from 0, and I am able to write to them no problem.

So that's an issue with the latest release it would seem.

Should I open an issue on Github? Not sure about the protocol on such things.