Parallella Community

Hello

I thought I would share with the community my custom board that I made for the parallella. The made aim of the board was to create a breakout for 5 fibre optic transceivers for that each run at 200Mbps. So far the design is working well and really happy with the result. This was made for the central controller for my full size humanoid robot.



For me info about the project see the webpage:



or read the paper here:



Thanks

Brennand Pierce

Woah! Now that is very cool indeed

Is the Parallella doing the control in the videos? And are you using the Epiphany, or just the ARM+FPGA at this point?

Regards,

Andrew