Cannot boot after adding FPGA accelerator

Using Zynq Programmable Logic and Xilinx tools to create custom board configurations

Re: Cannot boot after adding FPGA accelerator

Postby sebraa » Thu Jun 22, 2017 3:14 pm

olajep wrote:Try removing the epiphany module before reconfiguring the FPGA
Or remove the Epiphany device from the device-tree, which will prevent the epiphany module from being loaded in the first place.
sebraa
 
Posts: 495
Joined: Mon Jul 21, 2014 7:54 pm

Previous

Return to FPGA Design

Who is online

Users browsing this forum: No registered users and 3 guests