Parallella Community

by **censix** » Thu Jun 12, 2014 6:45 pm

Important:

Please note that the Epiphany always shows up as the second device in the list! The first evice d[[1]] is always the ARM host.
The Epiphany is d[[2]].

by **Tohru** » Fri Jan 02, 2015 1:52 pm

Thank you for your nice introduction of ROpenCL. I have tried to install it, but 'parallella-ROpenCL_0.1-1.patch' is not fit for ROpenCL 0.1-2. I hope the patch will be revised.

by **NelsCarlson** » Fri Aug 07, 2015 2:22 pm

by **piotr5** » Sat Aug 08, 2015 12:05 pm

not sure how much you know about patch.
basically you first type "cd pathname" where pathname is the location of whatever sourcecode. then do "patch -p1 <patchname" where patchname is the name of whatever patch-file you use, probably "../parallella-ROpenCL_0.1-1.patch" in your case. never tried "man patch"?

by **NelsCarlson** » Mon Aug 10, 2015 2:11 pm

by **piotr5** » Tue Aug 11, 2015 1:15 pm

why not use ? as mentioned above, you'd need to alter the files manually to reflect the changes intended by the patch...

by **davewr2015** » Sun Aug 30, 2015 1:05 am

Has anyone tested this with R3.03?

The latest README implies that it will work -- however -- as noted the patch files are out of date.

Any thoughts? Is there a new (working) procedure?

Parallella Community

How to access/use the E16/64 from the R prompt - Part 1

How to access/use the E16/64 from the R prompt - Part 1

Re: How to access/use the E16/64 from the R prompt - Part 1

Re: How to access/use the E16/64 from the R prompt - Part 1

Re: How to access/use the E16/64 from the R prompt - Part 1

Re: How to access/use the E16/64 from the R prompt - Part 1

Re: How to access/use the E16/64 from the R prompt - Part 1

Re: How to access/use the E16/64 from the R prompt - Part 1

Re: How to access/use the E16/64 from the R prompt - Part 1

Who is online